Fuel Pump Wiring & Sender Installation / Diagram

  1. For tank depths of 6” to 15‑1/2”, it will be necessary to remove the lower mounting bracket.
    a. Begin by removing the two screws and nuts from the lower mounting bracket. These will be discarded.
    b. Remove the two screws from the plastic rheostat housing. Save these screws to use later.
    c. Remove the plastic rheostat housing from the lower mounting bracket and then discard this portion of the mounting bracket.
    d. Reinstall the plastic rheostat housing to the upper mounting bracket and secure using the screws you removed in step “b”. (for tank depths 6‑7 inches, the top screw is not needed)

  2. Adjust the float length and pivot point for the tank’s depth. See diagram below.
    FLOAT SIDE